What are the differences between a repeater bridge and WDS?

Difference between Station WDS or Access Point WDS Sorry if this is not an intelligent question, but what is the difference between station wds or access point wds in the wireless mode of the Air OS page?1. Should my Omni directional antenna be in Station mode wds or Access point wds?2. Should the antenna's with M5 Bullets that aim at the Omni Manual:Wireless Station Modes - MikroTik Wiki With station-wds mode, it is not possible to connect to CAPsMAN controlled CAP. Mode station-pseudobridge. From the wireless connection point of view, this mode is the same as standard station mode. It has limited support for L2 bridging by means of some services implemented in station: EnGenius WDS Bridging Guide and Setup Example

4. Set Wireless mode to "Station" and enable WDS (Transparent Bridge Mode). 5. Confirm channel width matches AP configuration (20MHz in this example or Auto 20/40MHz). 6. If using Wireless Encryption, set "Security" to WPA2-AES/PSK. 7. Set the SSID to match the AP or use the "Select" button to find the Mixed Mode Wireless Network.

The 2 options which seem relevant are Network Mode and Wireless Mode. The options for Network Mode are: Bridge; Router; SOHO Router; The options for Wireless Mode are: Station; Station WDS; Access Point; Access Point WDS; From what I've read and what I want OpenWrt Project: Atheros and MAC80211 WDS to implement a Most OpenWrt supported wireless drivers support since kernel 2.6 the AP-to-STA WDS mode to connect two or more devices using wireless bridging to form one common broadcast domain.. With this configuration you will be able to wirelessly connect a remote wireless OpenWrt device (acting as the wireless station) to a local wireless OpenWrt point (acting as the wireless access point) and the wired

OpenWrt Project: Atheros and MAC80211 WDS to implement a

Knowledge Base | Buffalo Americas Set the mode switch on the AirStation to "WB". Depending on the model, the mode switch can be found on either the bottom or behind the AirStation. Connect the AirStation to a computer with an Ethernet cable and power both devices on. Move the AirStation next to the existing wireless access point. LigoDLB Series Configuration Scenarios - LigoWave set Wireless mode to Station (WDS/iPoll 2/iPoll 3). Leave all other settings as their default values. enable Security, if necessary; set the SSID. Monitor the indicator on the access point to confirm that all stations are connected. Monitor signal levels on both the Access Point and the Station. Setting Up a Point-to-Point Link using WDS Bridge Mode Jul 03, 2014